Opel Astra H a Zafira B forum

Tak se chystam dodelat na mem DVD 90 aux in vstup, bohuzel po aktivaci pres opcom to dela prd prd prd Zajedu do gm na nakup tech par vecicek a pustim se do letovani Nasel jsem navod pro cd70 a doufam ze DVD90 je po strance HW na dodelani aux in vstupu stejne.

hod sem ten navod

swabel píše:hod sem ten navod

http://leteckaposta.cz/617112950

nebo

http://www.megaupload.com/?d=XHHKRNKT

I am not blaming you at all for selling this on, it might be a good idea to explain just how small the SMD components are though. People who are not used to handling SMDs and don't have some basic equipment (specialist tweezers/temp controlled iron) and some basic competence in using them are not going to have a chance and will fry the components (and possibly their CD70's) in seconds

This is quite true. That's why i am saying average skill. However i think special tools is not required (at least for me). Most important is timing, as a rule of thumb, max soldering time is 3 seconds for IC and 5 seconds for caps/resistors per pin. I use a non-temp control solder iron and steal a tweezer from my wife, and finish all this. (I moved all high end tools to lab so only some basic tools at home).

So, personal soldering suggestion is:

Use a small tip solder iron, temperature not over 400 degree if possible.
DO NOT PUT YOUR IRON ON PCB FOR TOO LONG, IF YOU HAVEN'T SOLDERED A PIN SUCCESSFULLY IN ONE TIME, ALLOW SOME TIME (E.G. 10 SECONDS) TO COOL DOWN AND RETRY.
Use plenty of solder flux will help protect the Parts and Pads.

Also in the last picture of component location,
C9, Upper pin is negative and Lower pin is positive,
C8, Left pin is positive and Right pin is negative,

primo PDF mi nejde vlozit.....

Vdaka. Mozno sa raz do toho pustim aj ja.

Fajn navod na dorobenie AUX do kazdej CD70tky, ktora ho nepodporuje.
http://havver.velemer.hu/havver/files/CD70Navi_AUX.pdf

Zdravim, mam radio CD30 mp3 ale ako som sa tu na fore docital neda sa dorobit na mojom radiu aux :/ ... Da sa na tychto radiach odmontovat kryt radia? lebo by som to vedel vymenit z druheho auta tiez CD30 mp3 a tam je aux v aute uz spraveny.

Na co by som si mal davat pozor pri meneni radii..

Dakujem

Odmontovat kryt samozřejmě jde, ale nevím, k čemu by Ti to bylo ... Jestli jenom proto, aby jsi z jiného auta vzal celé rádio které podporuje AUX, vyměnil čelní panel, odpároval staré a připároval nové, tok to samozřejmě jde ...

Tzn. jenom vyměnit rádia bez programování nelze ...

Presne na to lebo jedno je čierne a druhe šede aby to nevyzeralo škaredo.

Okej vdaka za radu

RomanK píše:CDC40 Opera ani CDC40 Opera MP3 nemá AUX a ani k ní nelze připojit subwoofer. Ani jednu z těchto variat nelze naprogramovat.

Nechci dělat chytrého, ale ty vstupy tam k něčemu jsou.
Na netu jsem našel video s rádiem CDC 40 OPERA spolu s nastavitelným menu pro subwoofer. (2:33 - 2:40)
http://www.youtube.com/watch?v=QrKrTQLE2LY

Aux by mohl fungovat při obsazení jednotky DAB.
Problém je v tom, že těch rádii je tak málo.

Ale slovo nelze se mi nelíbí!!!

Pokud v rádiu chybí dosazené součástky viz. foto, nebude AUX IN fungovat ani po aktivaci pomocí Tech2.